Specification Sheet

Flara™ Accessories Technical Specication
Towel Bar YB0386, YB0318, YB0324
Stock Numbers:
YB0386CH – 9" Towel Bar
Chrome
YB0386BN – 9" Towel Bar
Brushed Nickel
YB0386NL – 9" Towel Bar
Polished Nickel
YB0386BG – 9" Towel Bar
Brushed Gold
YB0318CH – 18" Towel Bar
Chrome
YB0318BN – 18" Towel Bar
Brushed Nickel
YB0318NL – 18" Towel Bar
Polished Nickel
YB0318BG – 18" Towel Bar
Brushed Gold
YB0324CH – 24" Towel Bar
Chrome
YB0324BN – 24" Towel Bar
Brushed Nickel
YB0324NL – 24" Towel Bar
Polished Nickel
YB0324CH – 24" Towel Bar
Brushed Gold
Cleaning Instructions:
To preserve the ne nish of this product, clean only with a soft damp
cloth. Dry well. Do not use commercial or abrasive cleaners.
Installation Instructions:
Materials:
Towel Bar posts are constructed of
zinc. Bar is stainless steel.
25300 AL MOEN DRIVE • NORTH OLMSTED, OH 44070
CORPORATE HEADQUARTERS: [phone] • FAX: [phone]
INTERNATIONAL: (440 ) 962-2000 • FAX: [phone]
CUSTOMER SERVICE (USA): 800-882-0116 • FAX: [phone]
WWW.MOEN.COM
©Copyright Moen Incorporated
Stock Number: ________________________ Towel Bar
By Moen Incorporated
Dimensions:
4"
102mm
A
2-1/8"
54mm
4"
102mm
A
2-1/8"
54mm
1. Position the mounting template on the wall in the desired location.
2. Using a level, align the template and tape it to the wall.
3. Using the horizontal holes for drywall installation OR the vertical holes
for installation into a stud, mark the hole locations at each mounting post for your
corresponding product OR drill two ¼" pilot holes at the corresponding location.
4. Remove the template from the wall.
5. Using a #2 Phillips head screwdriver, screw the provided anchors into the wall
until ush.
6. Remove mounting post from the product assemblies by loosening each set screw
with the provided hex wrench.
7. One at a time, place each mounting post over the anchors (with the arrow facing
up) and insert provided screws through the post into the anchors.
8. Tighten screws.
9. Assemble the towel bar and posts.
10. While assembled, position each end post with setscrews facing down and place
over both mounting posts. Tighten the setscrew at the bottom of each post.
A
YB0386 9" (229mm)
YB0318 18" (457mm)
YB0324 24" (610mm)