Specification Sheet

Flara ™ Technical Specication
Drawer Pull YB0307
Stock Numbers:
Materials:
Dimensions:
Installation Instructions:
Cleaning Instructions:
YB0307BN – Drawer Pull
Brushed Nickel Finish
YB0307CH – Drawer Pull
Chrome Finish
YB0307NL – Drawer Pull
Polished Nickel Finish
YB0307BG – Drawer Pull
Brushed Gold Finish
1. Drawer pulls will require two 3/16" holes.
2. The distance between holes is 3" on center.
3. Using a level, mark the location of the two holes.
4. Use a 3/16" drill bit to drill two holes.
5. Insert the screws into each hole.
6. Place the drawer pull over the screws.
7. Use a Phillips screwdriver to tighten screws.
To preserve the ne nish of this product, clean only with a soft
damp cloth. Dry well. Do not use commercial or abrasive cleaners.
Drawer Pulls are constructed of zinc.
Stock Number: _____________________ Drawer Pull
By Moen Incorporated
25300 AL MOEN DRIVE • NORTH OLMSTED, OH 44070
CORPORATE HEADQUARTERS: [phone] • FAX: [phone]
INTERNATIONAL: (440 ) 962-2000 • FAX: [phone]
CUSTOMER SERVICE (USA): 800-882-0116 • FAX: [phone]
WWW.MOEN.COM
©
Copyright Moen Incorporated
4.39”
(112.5)
1.75”
(44mm)
.90”
(23mm)
4.39”
(112.5)
1.75”
(44mm)
.90”
(23mm)