Specification Sheet

Flara™ Accessories Technical Specication
Double Robe Hook YB0303
Stock Numbers:
Materials:
Dimensions:
Cleaning Instructions:
YB0303BN – Double Robe Hook
Brushed Nickel Finish
YB0303CH – Double Robe Hook
Chrome Finish
YB0303NL – Double Robe Hook
Polished Nickel
YB0303BG – Double Robe Hook
Brushed Gold
1. Position the assembled unit on the wall where desired.
2. Using a level, align the provided template and tape it to the wall.
3. Mark the desired hole locations through the template (such as tracing or
poking holes).
4. Remove the mounting bracket from the body by loosening the setscrew.
5. Center mounting bracket within the base outline with “UP” facing you.
6. Attach the mounting bracket to the wall, using the wall anchors provided.
7. Mount the base on the corresponding mounting bracket. Check and make
sure that the base screw hole is facing down. Assemble a set screw to the
base. Use the allen wrench included in a hardware kit to tighten the set
screw and secure the assembly to the mounting bracket.
To preserve the ne nish of this product, clean only with a soft damp cloth. Dry
well. Do not use commercial or abrasive cleaners.
Robe Hooks are constructed of zinc.
Stock Number: _______________ Double Robe Hook
By Moen Incorporated
25300 AL MOEN DRIVE • NORTH OLMSTED, OH 44070
CORPORATE HEADQUARTERS: [phone] • FAX: [phone]
INTERNATIONAL: (440 ) 962-2000 • FAX: [phone]
CUSTOMER SERVICE (USA): 800-882-0116 • FAX: [phone]
WWW.MOEN.COM
©
2019 Moen Incorporated
3-1/4”
(82mm)
3-17/64”
(83mm)
3-13/16”
(97mm)
2-3/16”
(55mm)
Installation Instructions:
3-1/4”
(82mm)
3-17/64”
(83mm)
3-13/16”
(97mm)
2-3/16”
(55mm)
3-1/4”
(82mm)
3-17/64”
(83mm)
3-13/16”
(97mm)
2-3/16”
(55mm)