Specification Sheet

Arlys™ Technical Specication
Single Post Paper Holder Y5709
Stock Numbers: Dimensions:
Installation Instructions:
Cleaning Instructions:
Y5709CH – Paper Holder
Chrome
Y5709BN – Paper Holder
Brushed Nickel
Y5709BL – Paper Holder
Matte Black
Tools Required: Phillips screwdriver, drill, 1/4” drill bit, hammer, level, tape
Hardware Kit Contents: 2 anchors, 1 hex wrench.
Note: Directions below are for installation into drywall. If installing product
into a stud, use the wood screws only.
1) Remove mounting posts from the product assemblies by loosening setscrew.
2) Position the mounting plate on the wall in the desired location and mark holes at the
Horizontal screw location on the template if installing into drywall or vertical screw
location if installing into a stud.
3) Drill 1/4” pilot holes in marked locations.
4) Lightly tap anchors until ush with the wall.
5) Place each mounting plate over anchors and insert screws through post into anchors.
6) Tighten screws.
7) Place posts over the mounting plates with setscrew facing down and tighten setscrew.
To preserve the ne nish of this product, clean only with a soft damp cloth.
Dry well. Do not use commercial or abrasive cleaners.
Materials:
Paper Holder is constructed of zinc.
Stock Number: ____________________Y5709 Paper Holder
25300 AL MOEN DRIVE • NORTH OLMSTED, OH 44070
CORPORATE HEADQUARTERS: [phone] • FAX: [phone]
INTERNATIONAL: (440 ) 962-2000 • FAX: [phone]
CUSTOMER SERVICE (USA): 800-882-0116 • FAX: [phone]
WWW.MOEN.COM
©
2021 Moen Incorporated. Moen is a registered trademark and Arlys is a trademark of Moen
Incorporated. All rights reserved.
2-3/4"
(70mm)
6-1/8"
(156mm)
Ø2-5/32"
(55mm)