Dimensions Guide

 Y3222BN – 24” Double Towel
Bar
Brushed Nickel Finish
 Y3222CH – 24” Double Towel
Bar
Chrome Finish
25300 AL MOEN DR IVE  N OR TH OLMSTED , OH 44070
C OR POR ATE H EAD QU AR TER S: (800) 321 -8809  FAX: [phone]
I NTER N ATI ON AL: [phone]  F AX: [phone]
C U STOMER SER VI C E (U SA): 800 -882-0116  F AX: [phone]
W W W . MOEN . C OM
Copyright Creative Specialties International Literature # BA1599
Towel Bar post is die cast from
highest quality zinc alloy (Zamac).
Casting is plated Chrome or Brushed
Nickel. Towel bar is aluminum.
Cleaning Instructions:
1. Position the mounting template on the wall in the desired location.
2. Using a level, align the template and tape it to the wall.
3. Drill two 5/16” holes at each mounting plate location that
corresponds to your product.
4. Remove the template from the wall.
5. Fold ends of the plastic toggle together and insert into each hole
in the wall.
6. Lightly tap anchors until flush with the wall.
7. One at a time, insert plastic pin into each of the anchors and
lightly tap to activate anchor. Remove pin and repeat on all
anchors.
8. Remove mounting pates from the posts by loosening each
setscrew.
9. Place the mounting plate on the wall over the installed wall
anchors with “UP” facing you.
10. Insert screws through the mounting plate into the anchors.
Tighten the screws.
11. Assemble the towel bar and posts.
12. While assembled, position each end post with setscrews facing
down and place over both mounting plates. Tighten the
setscrews.
Stock Number:______________________Double Towel
Bar By Creative Specialties
Materials:
Installation Instructions:
Stock Numbers:
Dimensions:
24” Double Towel Bar
Y3222
Boardwalk Technical Specification
To preserve the fine finish of this product, clean only with a soft
damp cloth. Dry well. Do not use commercial or abrasive cleaners.