Installation Manual

Mounting Bracket Installation Prep: Drill both marked holes using a 3/16” drill bit.

Note: Only drill through finished wall.

Mounting Bracket Installation: Apply a bead of silicone caulking within the mounting bracket

(A) groove. Adhere bracket to finished wall. Ensure data cable (B) goes through bracket

opening. Secure with screws and check that the bracket is level.

Connect Data Cable: Remove and discard protective cap from data cable (B) and attach cable

from controller cable (D) to data cable (B).

Mount Controller: Feed cabling connection (B & D) back into the wall through the mounting

bracket (A). Then attach controller (E) to bracket (A) as shown. Fully engage controller by

sliding it down into place. Installation is complete.

Getting Started

Initial Controller Setup

Set up your shower controller by establishing controller settings, including language, time zone

and optional Water Savings Mode.

Start Your Controller: To begin, press the power button in the center of the button pad to start the

initial setup process. You will be directed to the first setup screen.

Select Language: Using the hot/cold arrow keys on the button pad to scroll up and down, select a

language—English, French or Spanish. Press the identified outlet button (labeled “Done”) to

confirm the highlighted selection and move to the next screen.

Select Time Zone: Select your preferred temperature units, time zone and country using the

hot/cold arrow keys to scroll. Press the identified outlet button (labeled “Done”) to confirm the

highlighted selection and move to the next screen.