Installation Manual

end of the data cable to prevent it from falling back into the wall. Insert the other end of the cable
into the data port at the bottom of the valve.
10
Connecting Power Plug: Plug AC power adapter (K) into AC outlet within wood studs. Ensure
that AC power adapter is within 5 ft. (152 cm) of the shower valve (F) and has continuous
power. Insert plug into port underneath shower valve.
Controller Installation and Mounting
The U by Moen shower digital controller mounts easily and connects to the digital valve through
a waterproof data cable. A minimum space of 10 x 6 is required for the controller either inside
the shower or on an easily accessible wall adjacent to the shower (in-shower is recommended).
The controller can only be mounted in the horizontal position. Download Controller Installation
Guide
 For controller setup, including language, time zone, water temperature scale and water
saving mode, see the How To Use section.
 Be sure to reference the recommended mounting dimensions diagram before beginning
to install the controller.
How to Install the Controller:
1
Mounting Bracket: Finished wall should have a 1” hole for the data cable. Make sure the data
cable (B) has been pulled through the wall with slack and make certain that the data cable
doesn’t fall behind the wall. Next, level the mounting bracket (A) on the finished wall and mark
drill holes within the bracket. Set mounting bracket (A) aside.
2