Installation Manual

1
Prep Valve: Shutoffs are required for installation and/or servicing of shower valve. Turn both
shut-off valve handles to the off position.
2
Add Supports: First, note required distance between 2” × 4” supports for proper valve mounting
and install two 2” × 4” wood supports in between studs for valve mounting. Then secure each
support with wood screws (not provided).
3
Mount Valve: Mount shower valve (F) to both wood supports as shown. Shower valve should
rest on lower wood support.
4
Secure Valve: Use provided shower valve mounting screws (L) to secure shower valve (F);
tighten screws.
5
Outlet Caps: Remove and discard outlet protective caps (B) from top of shower valve. Then
remove and discard inlet protective caps (I) from bottom of shower valve.
6
Connections: Make plumbing connections to inlets and outlets as determined. Plumb outlet A to
the primary showerhead.
7
Unused Outlets: Plug any unused outlets (outlet cap [A] not included).
8
Controller Support: Identify desired controller location and install a 2” × 4” wood support
approximately 60” high for mounting controller. Secure the support with wood screws, then drill
a 1¼” hole through the middle. Refer to the diagram for detailed instructions.
9
Connecting Data Cable: Note cable connector ends; connect valve end to valve. Guide the data
cable (P) through the hole in the wood support. Attach the data cable retainer to the controller