Installation Manual

 If the shower is set up to be in Water Savings Mode, only one outlet can be turned
on at a time. Pressing another outlet will toggle the outlets from one to the other.
 The factory setting defaults to the top outlet (outlet A). Pressing another outlet button
will turn on an additional outlet so that multiple outlets will be flowing (unless Water
Savings Mode has been activated during initial setup).
Saving Controller Presets
You can program the two U by Moen shower controller preset buttons to each start a preferred
shower experience, ready at the push of a button. Once you find the temperature you prefer and
identify which outlets you want to have on, you can save those settings for future use.
1
To save a preset, simply press and hold the desired preset button (1 or 2) for a few seconds to
maintain the current settings.
2
Once the settings are saved, you will hear a tone and see an on-screen notification. There will
also be text in the bottom left of the screen indicating that these current shower settings reflect a
preset. After a few seconds, the screen will transition back to the shower status screen.