Technical Specifications

CSI SecureMount Anchors meet or
exceed the applicable requirements of
the following standards:
ANSI A117.1
ASTM F446
CSA B45
CSA B651
For use only when securely installed in
approved substrates* for persons no
more than 300lbs.
*Requires a 3½” space behind the wall
and works in the following substrates
• 1/2” or 5/8 ” Dry Wall
• 1/2” or 5/8 ” Dry Wall with Tile
• 1/2” or 5/8 ” Dry Wall with Marble
• 1/8” or 1/4 ” Fiberglass Tub Surround
SecureMount Anchor
mounting
plate
is made of stainless steel.
SecureMount Anchor guide and
anchor are made of POM.
q
SMA1000CH
–
SecureMount
Anchors
Chrome Finish
2 Anchors
q SMA1000PB –SecureMount
Anchors
Polished Brass Finish
2 Anchors
q SMA1000OWB –SecureMount
Anchors
Old World Bronze Finish
2 Anchors
q SMA1001CH –SecureMount
Anchors
Chrome Finish
20 Anchors
Direction for wall mounting installation:
1. Position grab bar on wall in desired location and mark around the outside of the flanges.
2. One at a time, center the mounting plate within the marked flanges, and mark the center
hole for drilling.
3. Drill one 1¼” hole at each mounting location.
4. Insert guide sleeves into each hole in the wall. (Note: UP indicator must always point up
regardless of grab bar orientation)
5. Connect pull tab to the secure mount anchor.
6. With pull tab up, insert the anchor all the way into the hole in the wall.
7. Pull back on the pull tab, and disconnect it from the anchor.
8. Place mounting plate over the hole and secure with the anchor screw, and flat and
rubber washers. (Note: Bar indicators should be facing in, align arrows)
9. Align the grab bar flanges to the secure mount anchor and secure with flange screws
and split lock washer.
Directions for stud mounting installation:
1. Position grab bar on wall in desired location and mark around the outside of the flanges.
2. Determine stud center and drill one 1/8” pilot hole at each location.
3. Install wood screw supplied with grab bar.
4. Install the 3 additional wood screws through the grab bar flange into the elongated
mounting plate slots.
Stock Number:
_______________
SecureMount Anchor
By Creative Specialties
Materials:
Installation Instructions:
Stock Numbers:
Dimensions:
SecureMount Anchor
SMA1000
Home Care Technical Specification
25300 AL MOEN DRIVE
•
NORTH OLMSTED, OH 44070
CORPORATE HEADQUARTERS: (800) 321- 8809 • FAX: [phone]
INTERNATIONAL: (440) 962- 2000 • FAX: [phone]
CUSTOMER SERVICE (USA): 800-882-0 116 • FAX: [phone]
WWW.HOMECARE. MOEN.COM
Copyright Creative Specialties International 2006
Literature #BA1387
Compliance: