Specification

1. Remove mounting bracket from back of fixture by loosening the set
screw.
2. Position unit on wall in desired location.
3. Lightly mark the outline of the base of the unit.
4. Center mounting bracket inside the outline.
5. Mark hole locations. Attach bracket to wall using 1 3/8” screws
(provided).
6. Mount base on bracket. Tighten set screw on the bottom.
Note: Wood blocking is preferable behind all wall surfaces.
If wood blocking is not available, the following optional fasteners are
suggested: Tile/Masonry – Plastic or Lead Anchors; Plaster/Drywall –
Toggle Bolts.
25300 AL MOEN D RI VE  N OR TH OLMSTED , OH 44070
C OR POR ATE H EAD QU AR TERS: (800) 321 -8809  F AX: [phone]
I N TERN ATI ON AL: (440) 962 -2000  F AX: (440) 962 -2726
C U STOMER SER VI C E (U SA): 800-882-0116  F AX: [phone]
W W W . MOEN . C OM
Copyright Creative Specialties International
Toothbrush and Soap Holders are
die cast from highest quality zinc alloy
(zamac). Castings are triple plated
with a polished brass or a polished
chrome finish.
 P5340 – Toothbrush Holder
Polished Chrome Finish
Concealed Screw Mounting
 P5360 – Soap Holder
Polished Chrome Finish
Concealed Screw Mounting
Cleaning Instructions:
Stock Number:___________Toothbrush & Soap Holder
By Creative Specialties
Materials:
Installation Instructions:
Stock Numbers:
Dimensions:
Toothbrush & Soap Holders
P5340 & P5360
Contemporary Technical Specification
To preserve the fine finish of this product, clean only with a soft
damp cloth. Dry well. Do not use commercial or abrasive cleaners.
Literature #BA0994