Specification

Idora
™
Technical Specication
18in. and 24in. Towel Bar
MY3718/MY3724
Stock Numbers:
Materials:
☐
MY3718CH - 18in. Towel Bar
Chrome Finish
☐
MY3724CH - 24in. Towel Bar
Chrome Finish
Towel Bar is constructed of zinc.
Dimensions:
Installation Instructions:
Cleaning Instructions:
Stock Number MY3718
Stock Number MY3724
Towel Bar By MOEN
To preserve the ne nish of this product, clean only with a soft
damp cloth. Dry well. Do not use commercial or abrasive cleaners.
25300 AL MOEN DRIVE • NORTH OLMSTED, OH 44070
CORPORATE HEADQUARTERS: (800) 321 -8809 • FAX: [phone]
INTERNATIONAL: (440) 962 -2000 • FAX: [phone]
CUSTOMER SERVICE (USA) : 800 -882-0116 • FAX: [phone]
WWW.MOEN.COM
© 2017 Moen Incorporated. Moen is a registered trademark and Idora is
a trademark of Moen Incorporated. All rights reserved.
1) Position the mounting template on the wall in the desired location.
2) Using a level, align the template and tape it to the wall.
3) Drill two ¼” holes at each mounting post location that corresponds to your
product. (We recommend using the horizontal holes for drywall installation).
4) Remove the template from the wall.
5) Lightly tap anchors until ush with the wall.
6) Remove mounting posts from the product assemblies by loosening
each setscrew.
7) One at a time, place each mounting post over anchors (notch facing
downward) and insert screws through post into anchors.
8) Tighten screws.
2"
50.80mm
24"
609.60mm
2"
50.80mm
18"
457.20mm
XXX”
XXmm
XXX”
XXmm
3-1/4"
83.51mm