Use and Care Manual

8
Tighten all three 1½" Screws (E) evenly and rmly against the
Backup Flange (D). DO NOT OVERTIGHTEN! Trim o excess
sealant in the sink.
Tighten all three 1½” Screws (E) evenly and rmly against the
Backup Flange (D). DO NOT OVERTIGHTEN! Trim o excess
sealant in the sink.
Tighten all three 1½” Screws (E) evenly and rmly against the
Backup Flange (D). DO NOT OVERTIGHTEN! Trim o excess
sealant in the sink.
E
D
x3
6
ATTACHING DISCHARGE ELBOW/ CONNECTING DISPOSAL TO MOUNT ASSEMBLY
ATTACHING DISCHARGE ELBOW/ CONNECTING DISPOSAL TO MOUNT ASSEMBLY
ATTACHING DISCHARGE ELBOW/ CONNECTING DISPOSAL TO MOUNT ASSEMBLY
Rubber Gasket
Rubber Gasket
Rubber Gasket
7
K
M
L
Install the provided pre-assembled discharge elbow/gasket
assembly and ange. Install and tighten two screws evenly
with a screw driver. DO NOT RE-USE THE EXISTING
DISCHARGE ELBOW AND GASKET AS THE GASKET MAY NOT
SEAL PROPERLY. USE ONLY THE NEW ELBOW, GASKET,
FLANGE AND SCREWS PROVIDED. DO NOT OVER TIGHTEN!
Install the provided pre-assembled discharge elbow/gasket
assembly and ange. Install and tighten two screws evenly
with a screw driver. DO NOT RE-USE THE EXISTING
DISCHARGE ELBOW AND GASKET AS THE GASKET MAY NOT
SEAL PROPERLY. USE ONLY THE NEW ELBOW, GASKET,
FLANGE AND SCREWS PROVIDED. DO NOT OVER TIGHTEN!
Install the provided pre-assembled discharge elbow/gasket
assembly and ange. Install and tighten two screws evenly
with a screw driver. DO NOT RE-USE THE EXISTING
DISCHARGE ELBOW AND GASKET AS THE GASKET MAY NOT
SEAL PROPERLY. USE ONLY THE NEW ELBOW, GASKET,
FLANGE AND SCREWS PROVIDED. DO NOT OVER TIGHTEN!
Using a blunt instrument (steel punch or wooden dowel),
knock out the entire plug in the dishwasher inlet. Do not use a
screwdriver or sharp instrument. IMPORTANT: Do not remove
the gasket and place it on the disposal between the elbow and
disposal. It must stay on the elbow to make a proper seal.
When the plug has been knocked into the disposal, it should be
removed using a pair of kitchen tongs and thrown away.
Using a blunt instrument (steel punch or wooden dowel),
knock out the entire plug in the dishwasher inlet. Do not use a
screwdriver or sharp instrument. IMPORTANT: Do not remove
the gasket and place it on the disposal between the elbow and
disposal. It must stay on the elbow to make a proper seal.
When the plug has been knocked into the disposal, it should be
removed using a pair of kitchen tongs and thrown away.
Using a blunt instrument (steel punch or wooden dowel),
knock out the entire plug in the dishwasher inlet. Do not use a
screwdriver or sharp instrument. IMPORTANT: Do not remove
the gasket and place it on the disposal between the elbow and
disposal. It must stay on the elbow to make a proper seal.
When the plug has been knocked into the disposal, it should be
removed using a pair of kitchen tongs and thrown away.
Knock Out Plug
Knock Out Plug
Knock Out Plug
*Only perform this step if connecting disposal to dishwasher
*Only perform this step if connecting disposal to dishwasher
*Only perform this step if connecting disposal to dishwasher
8
https://www4.citizens-
bankonline.com/efs/ser vlet/
efsonline/invalidate-session.
jsp?8207ea5d3e19a5fd