User manual

7- Program a Preset

7.1 Program loops and footswitches

7.2 Program Midi

Recall a preset and make sure the lock switch is at unlock position, pressing

LP3/4/5 buttons to turn on/off loop loop3/4/5. Pressing LPG/LPB button to change

the sequence of loop green/blue, or bypass them.

There are two channels of PC#/CC# in the preset, make sure the program panel is

unlocked, hold the OK button for 2 seconds to start the midi program, firstly edit

the 1st PC# - screen shortly shows “P1" then restores its current value, the “PC”

led indicates PC# is being edited. To change the PC value, use MIDI + or MIDI -

button to scroll up/down the value (range 0~199, or off).

After the 1st PC# is done, press OK button to start the 1st CC# edit - screen shortly

display “C1" (capital letter C) then restore its current value (0~127, or off), the

“CN” led indicates the controller number is being edited, use MIDI+/- button to

change the number.

Press OK button to edit the controller value (range 0~127 or off) of the 1st CC# -

screen shortly display “c1" (lowercase letter c) then restore its current value, the

“CV” led indicates the controller value is being edited, use MIDI+/- button to

change the value.

Till now, the 1st channel of PC#/CC# has been edited, to edit the 2nd channel

of PC#/CC#, just press ok again to continue the same sequence as the1st channel.

To end midi program, hold OK button for 2 seconds again, all values will be

saved into

nonvolatile memory automatically.

Press ok

Hold OK for 2s

Press ok

Flow chart of midi program

6- Mute the Commander

MUTE switch mutes the output, at the same time the guitar signal goes to the

TUNER jack. Click MUTE switch again will cancel the mute.

Note: Recall preset will clear the mute too.