Manualshelf

Use and Care Manual

ManualsBrandsMOEN ManualsAppliancesEX Series 3/4 HP Continuous Feed Space Saving Garbage Disposal
12345678910
6
INSTALLATION OF MOUNTING ASSEMBLY READ COMPLETELY BEFORE STARTING. NOTE: Pay close attention to the order of the mounting
assembly parts, as they have been correctly assembled by the factory.
INSTALLATION OF MOUNTING ASSEMBLY READ COMPLETELY BEFORE STARTING. NOTE: Pay close attention to the order of the mounting
assembly parts, as they have been correctly assembled by the factory.
INSTALLATION OF MOUNTING ASSEMBLY READ COMPLETELY BEFORE STARTING. NOTE: Pay close attention to the order of the mounting
assembly parts, as they have been correctly assembled by the factory.
E
D
x3
1
Disassemble the mounting assembly from the disposal by turning
the lower mount ring until it disengages from the ramps on the
mounting ring and the sink ange assembly can be removed. Loosen
the 3-mount screws until the mounting ring can be moved up to the
backup ange.
Disassemble the mounting assembly from the disposal by turning
the lower mount ring until it disengages from the ramps on the
mounting ring and the sink ange assembly can be removed. Loosen
the 3-mount screws until the mounting ring can be moved up to the
backup ange.
Disassemble the mounting assembly from the disposal by turning
the lower mount ring until it disengages from the ramps on the
mounting ring and the sink ange assembly can be removed. Loosen
the 3-mount screws until the mounting ring can be moved up to the
backup ange.
Use a at blade screwdriver under one end of the snap ring to remove
it from the sink ange. Remove the mounting ring, backup ange
and ber gasket from the sink ange. Note the sequence of these
parts as they are stacked in the correct re-assembly sequence. Keep
these parts together and set aside. Note: Mounting assembly can
accomodate sink thickness up to 1/2" extended lenght sink ange
available on MOEN.COM.
Use a at blade screwdriver under one end of the snap ring to remove
it from the sink ange. Remove the mounting ring, backup ange
and ber gasket from the sink ange. Note the sequence of these
parts as they are stacked in the correct re-assembly sequence. Keep
these parts together and set aside. Note: Mounting assembly can
accomodate sink thickness up to 1/2" extended lenght sink ange
available on MOEN.COM.
Use a at blade screwdriver under one end of the snap ring to remove
it from the sink ange. Remove the mounting ring, backup ange
and ber gasket from the sink ange. Note the sequence of these
parts as they are stacked in the correct re-assembly sequence. Keep
these parts together and set aside. Note: Mounting assembly can
accomodate sink thickness up to 1/2" extended lenght sink ange
available on MOEN.COM.
2