Use and Care Manual

INS10477 - 8/15
3
REMOVAL OF OLD DISPOSAL TYPICAL INSTRUCTIONS, YOUR MODEL MAY VARY. If there is no disposal, skip to page 5.
Turn o power if hard wired or unplug if cord is used.
REMOVAL OF OLD DISPOSAL TYPICAL INSTRUCTIONS, YOUR MODEL MAY VARY. If there is no disposal, skip to page 5.
Turn o power if hard wired or unplug if cord is used.
REMOVAL OF OLD DISPOSAL TYPICAL INSTRUCTIONS, YOUR MODEL MAY VARY. If there is no disposal, skip to page 5.
Turn o power if hard wired or unplug if cord is used.
A B
C
If a dishwasher is installed, make sure the dishwasher is
not running. We recommend unplugging the dishwasher or
turning o the electrical power at the circuit breaker or fuse
box. Remove the dishwasher drain hose from the disposal.
If a dishwasher is installed, make sure the dishwasher is
not running. We recommend unplugging the dishwasher or
turning o the electrical power at the circuit breaker or fuse
box. Remove the dishwasher drain hose from the disposal.
If a dishwasher is installed, make sure the dishwasher is
not running. We recommend unplugging the dishwasher or
turning o the electrical power at the circuit breaker or fuse
box. Remove the dishwasher drain hose from the disposal.
Caution: Be sure to support the disposal while performing
this step or it may fall when the lower mounting ring is
disconnected from the mounting assembly. Remove disposal
from sink ange by turning lower mount ring to the left.
If you are unable to turn the mount ring, tap on one of the
extensions from the ring with a hammer. Some mounting
systems have tubular extensions. Inserting a screwdriver
into one tube will provide additional leverage for turning
the mount ring. Some disposals may require the removal of
a clamp. If your disposal is hard wired (metal shielded cable
not utilizing a wall plug), complete step D. If you utilize a
plug in cord, go on to step E.
Caution: Be sure to support the disposal while performing
this step or it may fall when the lower mounting ring is
disconnected from the mounting assembly. Remove disposal
from sink ange by turning lower mount ring to the left.
If you are unable to turn the mount ring, tap on one of the
extensions from the ring with a hammer. Some mounting
systems have tubular extensions. Inserting a screwdriver
into one tube will provide additional leverage for turning
the mount ring. Some disposals may require the removal of
a clamp. If your disposal is hard wired (metal shielded cable
not utilizing a wall plug), complete step D. If you utilize a
plug in cord, go on to step E.
Caution: Be sure to support the disposal while performing
this step or it may fall when the lower mounting ring is
disconnected from the mounting assembly. Remove disposal
from sink ange by turning lower mount ring to the left.
If you are unable to turn the mount ring, tap on one of the
extensions from the ring with a hammer. Some mounting
systems have tubular extensions. Inserting a screwdriver
into one tube will provide additional leverage for turning
the mount ring. Some disposals may require the removal of
a clamp. If your disposal is hard wired (metal shielded cable
not utilizing a wall plug), complete step D. If you utilize a
plug in cord, go on to step E.
Above sink
Encima del lavabo
Au-dessus de l'évier
Below sink
Debajo del fregadero
Sous l'évier
Icon Legend/Leyenda de Iconos/
Légende des icônes
Unplug the disposal or turn o the electrical
power at the circuit breaker or fuse box. Use a wrench to
disconnect the drain line where it attaches to the disposal
discharge tube.
Unplug the disposal or turn o the electrical
power at the circuit breaker or fuse box. Use a wrench to
disconnect the drain line where it attaches to the disposal
discharge tube.
Unplug the disposal or turn o the electrical
power at the circuit breaker or fuse box. Use a wrench to
disconnect the drain line where it attaches to the disposal
discharge tube.
Caution
Caution
Caution
Shock
Shock
Shock