Dimensions Guide

Preston™ Technical Specication
Paper Holder DN8408
Stock Numbers: Dimensions:
Installation Instructions:
Cleaning Instructions:
DN8408PB – Paper Holder
Polished Brass Finish
Concealed Screw Mounting
DN8408CH – Paper Holder
Polished Chrome Finish
Concealed Screw Mounting
DN8408MPW – Paper Holder
Matte Pewter Finish
Concealed Screw Mounting
DN8408BN – Paper Holder
Brushed Nickel Finish
Concealed Screw Mounting
DN8408OWB – Paper Holder
Old World Bronze Nickel
Concealed Screw Mounting
1. Position the mounting plate on the wall at desired location with
“UP” facing you.
2. One at a time, place each anchor screw through the mounting
plate, centered in each large hole. Using a Phillips screwdriver,
turn the anchor screw while applying pressure. Screw will self
drill and tap into drywall. Do not over tighten.
3. Place assembly over the mounting post, setscrew facing down.
4. Tighten setscrew.
To preserve the ne nish of this product, clean only with a soft damp cloth.
Dry well. Do not use commercial or abrasive cleaners.
Materials:
Paper Holder post is die cast from highest
quality zinc alloy (zamac). Castings are
triple plated with a polished brass, polished
chrome, or matte pewter nish.
Stock Number: ____________________Paper Holder
By Moen Incorporated
25300 AL MOEN DRIVE • NORTH OLMSTED, OH 44070
CORPORATE HEADQUARTERS: [phone] • FAX: [phone]
INTERNATIONAL: (440 ) 962-2000 • FAX: [phone]
CUSTOMER SERVICE (USA): 800-882-0116 • FAX: [phone]
WWW.MOEN.COM
©
2017 Moen Incorporated. Moen is a registered trademark and Lindor is a trademark of
Moen Incorporated. All rights reserved.