Specification

Tread Strips are made from white
polyvinyl chloride with a pebbled top
surface and a waterproof adhesive
backing.
 DN7045 – Bath Mat
White
Adhesive Backing
Blister Pack
6 Strips Per Package
25300 AL MOEN DRIVE  NORT H OL M ST ED, OH 4 4 0 7 0 (800) 321 -8809 
FAX: [phone]  INT E RNAT IONA L : (44 0 ) 962 -2000 
FAX: [phone] CUST OM ER SERVICE (USA): 800 -882-0116
WWW.M OEN.COM
©Co p yri gh t Cre a ti ve Speci al ti es In te rn a ti on a l Li te ra ture #BA 1 6 9 1
1. Prepare floor. Before beginning, make sure the tub or shower floor
is completely clean and dry.
2. Separate each strip from the roll and position it on the floor where it
will be applied. If needed, shorten each strip to the desired length
using scissors.
3. Prepare strips. Peel back 1” of backing paper on each strip.
CAUTION: Do not touch the adhesive backing under the paper.
4. Secure strips. Gently press down the exposed section of the
adhesive against the floor surface. Then, remove the remaining
paper, stopping periodically to gently press down the new exposed
section of each strip. The strips adhere immediately. No drying is
needed.
Stock Number:____________________Tread Strips
By Creative Specialties International
Materials:
Installation Instructions:
Stock Numbers:
Dimensions:
Tread Strips
DN7045
Home Care Technical Specification