Specification

Tub/Shower Seat is made from high
impact polypropylene. Legs are
anodized aluminum with a powder
coated white finish. Feet are gray
rubber.
WARNING
TO PREVENT SERIOUS OR FATAL INJURY:
Insure product is assembled and used properly.
FOR USE ONLY BY PERSONS WEIGHING
LESS THAN 250 POUNDS. Failure to follow
correct assembly procedures can cause the seat
to become unstable. DO NOT jump on, stand on
or tilt. Contact CSI immediately at 1-800-882-
0116 if any components are missing or damaged.
Do not modify or substitute any components.
FOR QUESTIONS OR ASSISTANCE WITH
ASSEMBLY CONTACT CSI AT 1-800-882-0116.
Consult healthcare professional for advice and
instructions specific to user’s needs before use.
 DN7035 – Tub/Shower Seat
White
Photo Box Packaging with Handle
25300 AL MOEN DRIVE  NORT H OLMST ED, OH 44070 (800) 321 -8809 
FAX: [phone]  INT ERNAT IONAL: (4 4 0 ) 9 6 2 -2000 
FAX: [phone] CUST OM ER SE RVICE (USA): 800-882-0116
WWW.MOEN.COM
©Copyright Creative Specialties International Literature #BA1682
1. Position legs. Place leg “1” into grove “1” of the plastic
seat panel so that the number “1” marks are next to each
other. Then place leg “2” into groove “2”, over leg “1” so
that the number “2” marks are next to each other.
2. Attach legs. Insert a 1 ½” screw through a washer and
the center hole of the legs and seat. Tighten several
turns. Insert remaining four screws through washers into
the four leg holes. Tighten all five screws fully. Test seat.
Retighten as needed.
Stock Number:__________________ Tub/Shower Seat
By Creative Specialties
Materials:
Installation Instructions:
Stock Numbers:
Dimensions:
Tub/Shower Seat
DN7035
Home Care Technical Specification