Specification
Low Grip Tub Safety Bar is made
from anodized aluminum with a powder
coat white finish.
WARNING
TO PREVENT SERIOUS OR FATAL INJURY:
Insure product is assembled, adjusted and used
properly. FOR USE ONLY BY PERSONS
WEIGHING LESS THAN 250 POUNDS. Failure
to follow correct installation procedures can
cause the grip to become loose. Check after
installation to make sure grip is secure, and
check periodically to be sure grip remains secure.
For use only to assist in balance while entering
and exiting tub. Contact CSI immediately at 1-
800-882-0116 if any components are missing or
damaged. Do not modify or substitute any
components. FOR QUESTIONS OR
ASSISTANCE WITH ASSEMBLY CONTACT CSI
AT 1-800-882-0116. Consult healthcare
professional for advice and instructions specific to
user’s needs before use.
DN7010 – Low Grip Tub Safety Bar
White
Photo Box Packaging with Handle
25300 AL M OEN DRIVE NORT H OLM ST E D, OH 4 4 070 (80 0 ) 3 2 1 -8809
FAX : (80 0 ) 8 4 8 -6636 INT ERNAT IONAL : (440 ) 9 6 2 -2000
FAX : (44 0 ) 9 6 2 -2726 CUST OMER SERVICE (USA ): 800 -882-0116
WWW.M OEN.COM
©Co pyright Cre ati ve Sp e ci al ti e s In tern a tional L i te rature #BA1687
1. Loosen A and B bolts to allow bar and clamps to be adjusted
to your tub.
2. Position the clamps to fit snugly against the sides and top rim
of the tub and then adjust B bolt. Do not tighten yet.
3. Use the wrench provided to tighten A bolts so that the clamps
are angled correctly for your tub.
4. Tighten B bolts firmly so that the clamp pads make secure,
continuous contact with both sides of the tub walls.
Retighten A and B bolts as necessary.
Stock Number:_____________Low Grip Tub Safety Bar
By Creative Specialties
Materials:
Installation Instructions:
Stock Numbers:
Dimensions:
Low Grip Tub Safety Bar
DN7010
Home Care Technical Specification