Technical Specifications

Robe Hook
is constructed of zinc with
a ceramic insert.
q
DN6303ORB
–
Robe Hook
Oil Rubbed Bronze Finish
q DN6303BNV – Robe Hook
Brushed Nickel & Ivory Finish
q DN6303WCH – Robe Hook
Chrome & White Finish
q DN6303BC – Robe Hook
Brushed Chrome Finish
Cleaning Instructions:
25300 AL MOEN DRIVE • NORTH OLMSTED, OH 44070 [phone] •
FAX: [phone] • INTERNATIONAL: [phone] •
FAX: (440) 962
-
2726 CUSTOMER SERVICE (USA): 800
-
882
-
0116
1.
Mounting hardware is included in the package.
2. Position the assembled unit on the wall where desired.
3. Lightly mark the outline of each base.
4. Remove the mounting brackets from back of the fixture by loosening the set
screws with the hex wrench provided.
5. Center a mounting bracket within each base outline.
6. Mark the hole locations of each mounting bracket.
7. Drill a ¼ inch hole at each location.
8. Insert the supplied plas
tic wall anchor into each drilled hole by lightly tapping it
in flush. Note: Mounting into wood studs is recommended whenever possible.
9.
Attach each mounting bracket to the wall, by using the mounting bracket screws.
10. Place the assembled product over the m
ounting bracket with the set screw facing
down.
11. Tighten the set screw with supplied hex wrench to secure the assembly to the
brackets.
Stock Number:
______________________Robe Hook
By CSI Bath Furnishings
Materials:
Installation Instructions:
Stock Numbers:
Dimensions:
Robe Hook
DN6303
Kelsey Technical Specification
To preserve the fine finish of this product, clean only with a soft
damp cloth. Dry well. Do not use commercial or abrasive cleaners.

Copyright CSI Bath Furnishing Division of Moen 02/22/01
Literature #BA1094
2.54 IN
2.55 IN DEEP
FROM FRONT
OF ROBE HOOK
TO WALL
3.125 IN