Installation Guide

25300 AL MOEN D R I VE  N OR TH OLMSTED , OH 44070
C OR POR ATE H EAD QU AR TER S: (800) 321 -8809  F AX: [phone]
I N TER N ATI ON AL: [phone]  FAX: [phone]
CUSTOMER SER VI C E (U SA): 800 -882-0116  F AX: [phone]
W W W . MOEN . C OM
Copyright Creative Specialties International Literature #BA1348
Directions below are for installation into drywall. If installing product into a stud, use the
w ood screws only.
1. Position the mounting template on the w all in the desired location.
2. Using a level, align the template and tape it to the w all.
3. Drill tw o 5/16” holes at each mounting post location. (We recommend using the
horizontal holes for drywall installation).
4. Remove the template from the w all.
5. Fold ends of the plastic toggle together and insert into each hole in the w all.
6. Lightly tap anchors until flush w ith the wall.
7. One at a time, insert plastic pin into each of the anchors and lightly tap to activate
anchor. Remove pin and repeat on all anchors.
8. Remove mounting posts from the product assemblies by loosening each setscrew.
9. One at a time, place each mounting post over anchors (notch facing downward)
and insert screws through post into anchors. Tighten screws.
10. Loosen the 2 small screws on each of the end posts.
11. With the back of the mirror facing you, slide both end posts into position on the
mirror. Align the screws with the holes in the back plates. Tighten all 4 screws.
12. Place entire mirror assembly over the mounting posts on the w all (setscrews facing
dow n). Tighten setscrews.
Oval Tilting Mirror posts are
constructed of zinc and mirror is
constructed of 5MM thick glass.
 DN0892ORB – Oval Tilting
Mirror
Oil Rubbed Bronze Finish
Cleaning Instructions:
Stock Number:___________________Oval Tilting Mirror
By Creative Specialties
Materials:
Installation Instructions:
Stock Numbers:
Dimensions:
Oval Tilting Mirror
DN0892
Gilcrest® Technical Specification
To preserve the fine finish of this product, clean only with a soft
damp cloth. Dry well. Do not use commercial or abrasive cleaners.