Specification

prim
Towel Bar post is die cast from the
highest quality zinc alloy (Zamac).
Casting is plated in chrome, brushed
nickel or oil rubbed bronze. Towel
bar is aluminum for brushed nickel
and chrome finishes and brass for oil
rubbed bronze.
 DN3618BN – 18” Towel Bar
Brushed Nickel Finish
 DN3624BN – 24” Towel Bar
Brushed Nickel Finish
 DN3618CH – 18” Towel Bar
Chrome Finish
 DN3624CH – 24” Towel Bar
Chrome Finish
 DN3618ORB – 18” Towel Bar
Oil Rubbed Bronze Finish
 DN3624ORB – 24” Towel Bar
Oil Rubbed Bronze Finish
Cleaning Instructions:
Stock Number:_____________________18” & 24” Towel Bar
By Creative Specialties
Materials:
Installation Instructions:
Stock Numbers:
Dimensions:
18” & 24” Towel Bar
DN3618 & DN3624
Bradshaw™ Technical Specification
To preserve the fine finish of this product, clean only with a soft
damp cloth. Dry well. Do not use commercial or abrasive cleaners.
25300 AL MOEN DRI VE  N ORTH OLMSTED , OH 44070
C OR POR ATE H EAD QU AR TER S: (800) 321 -8809  F AX: [phone]
I N TER N ATI ON AL: (440) 962 -2000  F AX: (440) 962 -2726
C U STOMER SER VICE (U SA): 800 -882-0116  F AX: [phone]
W W W . MOEN . C OM
Copyright Creative Specialties International Literature #BA1510
1. Position the mounting template on the w all in the desired location.
2. Using a level, align the template and tape it to the w all.
3. Drill tw o 5/16” holes at each mounting post location that corresponds to your
product.
4. Remove the template from the w all.
5. Fold ends of the plastic toggle together and insert into each hole in the w all.
6. Lightly tap anchors until flush w ith the w all.
7. One at a time, insert plastic pin into each of the anchors and lightly tap to
activate anchor. Remove pin and repeat on all anchors.
8. Remove mounting posts from the product assemblies by loosening each
setscrew .
9. Place the mounting plate on the w all over the installed w all anchors w ith “UP”
facing you.
10. Insert screw s through the mounting plate into the anchors. Tighten the
screw s.
11. Assemble the tow el bar and posts.
12. While assembled, position each end post w ith setscrew s facing dow n and
place over both mounting posts. Tighten the setscrew at the bottom of each
post.