Specification

Directions below are for installation into drywall. If installing product into a stud, use the
w ood screws only.
1. Position the mounting template on the w all in the desired location.
2. Using a level, align the template and tape it to the w all.
3. Drill tw o 5/16” holes at each mounting post location that corresponds to your
product.
4. Remove the template from the w all.
5. Fold ends of the plastic toggle together and insert into each hole in the w all.
6. Lightly tap anchors until flush w ith the wall.
7. One at a time, insert plastic pin into each of the anchors and lightly tap to activate
anchor. Remove pin and repeat on all anchors.
8. Remove mounting posts from the product assemblies by loosening each setscrew.
9. One at a time, place each mounting post over anchors (with UP facing you) and
insert screws through post into anchors.
10. Tighten screws.
11. Assemble the tow el bar and posts.
12. While assembled, position each end post w ith setscrews facing down and place
over both mounting posts. Tighten the setscrew at the bottom of each post.
13. Position the mounting template on the wall in the desired location.
Using a level, align the template and tape it to the wall.
14. Remove each mounting post from the body by loosening the
setscrew.
15. Place each mounting post on the template with notch facing down.
16. One at a time, place each anchor screw through the mounting post,
centered in the large hole. Using a Phillips screwdriver, turn the
anchor screw while applying pressure. Screw will self drill and tap
into drywall.
17. Only insert screw ½ to ¾ of the way.
18. After all screws are installed, tear the template away from the wall.
19. Tighten all 4 the screws. Do not over tighten.
20. Assemble the Towel bar and posts.
21. While assembled, Position each end post with the setscrew down
and place over mounting posts. Tighten the setscrew at the bottom
of each base.
25300 AL MOEN D RI VE  NOR TH OLMSTED , OH 44070
C ORPOR ATE HEAD QUAR TER S: (800) 321 -8809  F AX: [phone]
I N TER N ATI ONAL: (440) 962 -2000  F AX: [phone]
C U STOMER SER VI C E (USA): 800 -882-0116  F AX: [phone]
WWW.MOEN . C OM
Copyright Creative Specialties International Literature #BA1247
Towel bar posts are constructed of
zinc. Bar is constructed of brass (BN)
or aluminum (CH).
 DN2618BN – 18” Towel Bar
Brushed Nickel Finish
 DN2624BN – 24” Towel Bar
Brushed Nickel Finish
 DN2618CH – 18” Towel Bar
Chrome Finish
 DN2624CH – 24” Towel Bar
Chrome Finish
Cleaning Instructions:
Stock Number:______________________Towel Bar
By Creative Specialties
Materials:
Installation Instructions:
Stock Numbers:
Dimensions:
18” & 24” Towel Bar
DN2618 & DN2624
Glenshire® Technical Specification
To preserve the fine finish of this product, clean only with a soft
damp cloth. Dry well. Do not use commercial or abrasive cleaners.