Specification

1. Position the mounting template on the w all in the desired location.
2. Using a level, align the template and tape it to the w all.
3. Drill tw o 5/16” holes at each mounting post location that corresponds to your
product. (We recommend using the horizontal holes for drywall installation).
4. Remove the template from the w all.
5. Fold ends of the plastic toggle together and insert into each hole in the w all.
6. Lightly tap anchors until flush w ith the wall.
7. One at a time, insert plastic pin into each of the anchors and lightly tap to
activate anchor. Remove pin and repeat on all anchors.
8. Remove mounting posts from the product assemblies by loosening each
setscrew.
9. One at a time, place each mounting post over anchors (notch facing
dow nward) and insert screws through post into anchors.
10. Tighten screws.
11. Assemble the tow el bar and posts.
12. While assembled, position each end post w ith setscrews facing down and
place over both mounting posts. Tighten the setscrew at the bottom of each
post.
25300 AL MOEN D R I VE  N OR TH OLMSTED , OH 44070
C OR POR ATE H EAD QUARTER S: (800) 321 -8809  F AX: [phone]
I N TER N ATI ON AL: (440) 962 -2000  F AX: [phone]
C U STOMER SER VI C E (U SA): 800 -882-0116  F AX: [phone]
W W W . MOEN . C OM
Copyright Creative Specialties International Literature #BA1349
Towel bar posts are constructed of
zinc. Bar is constructed of brass.
 DN0822ORB – 24” Double Towel
Bar
Oil Rubbed Bronze Finish
Cleaning Instructions:
Stock Number:__________________ Double Towel Bar
By Creative Specialties
Materials:
Installation Instructions:
Stock Numbers:
Dimensions:
24” Double Towel Bar
DN0822
Gilcrest® Technical Specification
To preserve the fine finish of this product, clean only with a soft
damp cloth. Dry well. Do not use commercial or abrasive cleaners.