Specification

25300 AL MOEN D R I VE  N OR TH OLMSTED , OH 44070
C OR POR ATE H EAD QU AR TER S: (800) 321 -8809  F AX: [phone]
I N TER N ATI ON AL: [phone]  FAX: [phone]
C U STOMER SER VI C E (U SA): 800 -882-0116  F AX: [phone]
W W W . MOEN . C OM
Copyright Creative Specialties International
Directions below are for installation into drywall. If installing product into a
stud, use the wood screws and washers provided only.
1. Position the mounting template on the w all in the desired location.
2. Using a level, align the template and tape it to the w all.
3. Drill tw o 5/16” holes as indicated on the template.
4. Remove the template from the w all.
5. Fold ends of the plastic toggle together and insert into each hole in the w all.
6. Lightly tap anchors until flush w ith the wall.
7. One at a time, insert plastic pin into each of the anchors and lightly tap to activate
anchor. Remove pin and repeat on all anchors.
8. Remove mounting posts from the product assemblies by loosening each setscrew.
9. Place the mounting plate on the w all over the installed w all anchors w ith “UP”
facing you.
10. Insert screws through the mounting plate into the anchors. Tighten the screws.
11. Unscrew the top accent cap from both assemblies. Reassemble w ith glass shelf
betw een both washers and finish by screwing top accent cap back on.
12. Place assembly over the mounting posts w ith setscrews facing down. Tighten both
setscrews.
Glass Shelf posts are constructed of
zinc. Shelf is tempered glass.
 DN0790CH – Glass Shelf
Chrome Finish
 DN0790BN – Glass Shelf
Brushed Nickel Finish
Cleaning Instructions:
Stock Number:________________________Glass Shelf
By Creative Specialties
Materials:
Installation Instructions:
Stock Numbers:
Dimensions:
Glass Shelf
DN0790
Iso™ Technical Specification
To preserve the fine finish of this product, clean only with a soft
damp cloth. Dry well. Do not use commercial or abrasive cleaners.
Literature #BA1404