Specification Sheet

25300 AL MOEN DRIVE
•
NORTH OLMSTED, OH 44070
CORPORATE HEADQUARTERS: (800) 321- 8809 • FAX: [phone]
INTERNATIONAL: (440) 962- 2000 • FAX: [phone]
CUSTOMER SERVICE (USA): 800-882-0116 • FAX: [phone]
WWW.CSI.MOEN.COM

Copyright Creati
ve Specialties International
Literature #BA1
401
Directions below are for installation into drywall. If installing product into a
stud, use the wood screws and washers provided only.
1) Position the mounting template on the wall in the desired location.
2) Using a level, align the template and tape it to the wall.
3) Drill two 5/16” holes at each mounting post location that corresponds
to your product.
4) Remove the template from the wall.
5) Fold ends of the plastic toggle together and insert into each hole in the
wall.
6) Lightly tap anchors until flush with the wall.
7) One at a time, insert plastic pin into each of the anchors and lightly tap
to activate anchor. Remove pin and repeat on all anchors.
8) Secure the EZ 2 Install wall bracket to the wall by inserting 2 screws
through the wall bracket holes and into the anchors. Tighten screws.
9) Assemble the towel bar and posts.
10) Place product posts over EZ 2 Install wall brackets and slide down to
loc
k into place.
Towel bar
posts are constructed of
zinc. Bars are constructed of
aluminum.
q
DN
07
22
CH
–
24
”
Double
Towel Bar
Chrome Finish
Cleaning Instructions:
Stock Number:
__________________ Double
Towel Bar
By Creative Specialties
Materials:
Installation Instructions:
Stock Numbers:
Dimensions:
24”
Double
Towel Bar
DN
07
22
Iso Technical Specification
To preserve the fine finish of this product, clean only with a soft
damp cloth. Dry well. Do not use commercial or abrasive cleaners.