Specification Sheet

ManualsBrandsMOEN ManualsBathIso Single Post Paper Holder in Spot Resist Brushed Nickel

25300 AL MO E N D R IVE  NO RTH O L M STE D, OH 44070

CO R P O RATE HE A D Q U ART ER S : (800 ) 3 2 1 -88 0 9  FA X: (800) 8 48 - 6 6 36

IN T E RNAT IO NA L : (440 ) 962 - 2 0 00  FA X: ( 4 4 0 ) 962 -2726

CU ST O MER S ERV ICE (USA): 800 -882 - 0 1 16  FA X: (88 8 ) 379 -2720

WWW .CSI . MOE N . C O M

Copyright Creative Specialties International

The Paper Holder can be mounted in three positions:

• Horizontal – paper loads from left facing (A)

• Horizontal – paper loads from right facing (B)

• Vertical – paper loads from top (C)

To change the orientation of the paper holder:

• Unscrew (C) from the back of base (B) to disconnect components

• Position Paper Holder Post (A) in desired position (horizontal facing left or right, vertical)

• Re-insert Paper Holder Post (A) into base (B); ensure set screw hole on base (B) is facing down

• Insert screw (C) into back of base (B) and tighten to secure all components

Note: Directions below are for installation into drywall. If installing product into a stud, use the wood screws only.

1) Remove mounting plate from product assembly by loosening the setscrew.

2) Position the mounting plate on the wall at desired location with “UP” facing you. Mark hole locations.

3) Drill 2 holes as marked using 5/16” drill bit.

4) Fold ends of the plastic toggle anchor together and insert into each hole in the wall.

5) Lightly tap anchors until flush with the wall.

6) One at a time, insert plastic pin into each anchor and lightly tap to activate anchor. Remove pin and repeat on other anchor.

7) Place the mounting plate on the wall over the installed wall anchors with "UP" facing you.

8) Tighten screws.

9) Place decorative product over the mounting plate with setscrew facing down and tighten setscrew.

Paper Holder is constructed of zinc.

 DN0709BN – Single Post Paper

Holder

Brush Nickel Finish

 DN0709CH – Single Post Paper

Holder

Chrome Finish

Cleaning Instructions:

Stock Number:______________________Paper Holder

By Creative Specialties

Materials:

Installation Instructions:

Stock Numbers:

Dimensions:

Single Post Paper Holder

DN0709

Iso Technical Specification

To preserve the fine finish of this product, clean only with a soft damp cloth. Dry well. Do not use commercial or

abrasive cleaners.

Literature #BA1531

(A)

(B)

(C)

(A)

(B)

(C)