Specification

25300 AL MOEN D R I VE  N OR TH OLMSTED, OH 44070
C OR POR ATE H EAD QU AR TER S: (800) 321 -8809  F AX: [phone]
I N TER N ATI ON AL: [phone]  FAX: [phone]
C U STOMER SER VI C E (U SA): 800 -882-0116  F AX: [phone]
W W W . MOEN . C OM
Copyright Creative Specialties International
Directions below are for installation into drywall. If installing product into a
stud, use the wood screws only.
1. Position the mounting template on the w all in the desired location.
2. Using a level, align the template and tape it to the w all.
3. Drill tw o 5/16” holes as indicated on the template
4. Remove the template from the w all
5. Fold ends of the plastic toggle together and insert into each hole in the w all.
6. Lightly tap anchors until flush w ith the w all.
7. One at a time, insert plastic in into each of the anchors and lightly tap to
activate anchor. Remove pin and repeat on all anchors.
8. Remove mounting posts from the product assemblies by loosening each set
screw .
9. Place the mounting plate on the w all over the installed w all anchors w ith “UP”
facing you.
10. Insert screw s through the mounting plate into the anchors. Tighten the
screw s.
11. Place each assembly over the mounting posts w ith the setscrew s facing
dow n. Pivoting posts w ith bar should be on the left side. Tighten both setscrew s
.
Paper Holder is constructed of zinc.
 DN0708BN – Paper Holder
Brush Nickel Finish
 DN0708CH – Paper Holder
Chrome Finish
Cleaning Instructions:
Stock Number:______________________Paper Holder
By Creative Specialties
Materials:
Installation Instructions:
Stock Numbers:
Dimensions:
Paper Holder
DN0708
Iso™ Technical Specification
To preserve the fine finish of this product, clean only with a soft
damp cloth. Dry well. Do not use commercial or abrasive cleaners.
Literature #BA1399