Dimensions Guide

Iso™ Technical Specication
Drawer Pull DN0707
Stock Numbers: Dimensions:
Installation Instructions:
Cleaning Instructions:
DN0707BN – Cabinet Knob
Brushed Nickel Finish
DN0707CH – Cabinet Knob
Chrome Finish
DN0707BG – Cabinet Knob
Brushed Gold Finish
DN0707BL – Cabinet Knob
Matte Black Finish
1. Drawer Pulls will require two 3/16" holes.
2. The distance between holes is 3" on center.
3. Using a level, mark the location of the two holes.
4. Use a 3/16" drill bit to drill two holes.
5. Insert the screws into each hole.
6. Place a drawer pull over the screws.
7. Use a Phillips screwdriver to tighten screws.
To preserve the ne nish of this product, clean only with a soft damp cloth.
Dry well. Do not use commercial or abrasive cleaners.
Materials:
Drawer Pulls are constructed of zinc.
Stock Number: _____________________ Drawer Pull
By Moen Incorporated
25300 AL MOEN DRIVE • NORTH OLMSTED, OH 44070
CORPORATE HEADQUARTERS: [phone] • FAX: [phone]
INTERNATIONAL: (440 ) 962-2000 • FAX: [phone]
CUSTOMER SERVICE (USA): 800-882-0116 • FAX: [phone]
WWW.MOEN.COM
©
2018 Moen Incorporated. Moen is a registered trademark and Iso is a trademark of Moen
Incorporated. All rights reserved.
4.06"
10.31cm
.59"
1.49cm
3.00"
7.62cm
1.28"
3.25cm
.98"
2.49cm