Specification Sheet

Iso™ Technical Specication
Cabinet Knob DN0705
Stock Numbers: Dimensions:
Installation Instructions:
Cleaning Instructions:
DN0705BN – Cabinet Knob
Brushed Nickel Finish
DN0705CH – Cabinet Knob
Chrome Finish
DN0705BG – Cabinet Knob
Brushed Gold Finish
1. Cabinet knobs will require one 3/16" hole.
2. Mark the location of the hole.
3. Use a 3/16" drill bit to drill hole.
4. Insert the screw into the hole.
5. Place knob over the screw.
6. Use a Phillips screwdriver to tighten screws.
To preserve the ne nish of this product, clean only with a soft damp cloth.
Dry well. Do not use commercial or abrasive cleaners.
Materials:
Cabinet Knobs are constructed of brass.
Stock Number: ___________________ Cabinet Knob
By Moen Incorporated
25300 AL MOEN DRIVE • NORTH OLMSTED, OH 44070
CORPORATE HEADQUARTERS: [phone] • FAX: [phone]
INTERNATIONAL: (440 ) 962-2000 • FAX: [phone]
CUSTOMER SERVICE (USA): 800-882-0116 • FAX: [phone]
WWW.MOEN.COM
©
2017 Moen Incorporated. Moen is a registered trademark and Iso is a trademark of Moen
Incorporated. All rights reserved.
ø
.86"
2.18cm
1.19"
3.02cm