Installation Sheet

25300 AL MOEN DRIVE
•
NORTH OLMSTED, OH 44070
CORPORATE HEADQUARTERS: (800) 321- 8809 • FAX: [phone]
INTERNATIONAL: (440) 962- 2000 • FAX: [phone]
CUSTOMER SERVICE (USA): 800-882-0116 • FAX: [phone]
WWW.CSI.MOEN.COM
Copyright Creative Specialties International 2006
Shower Rod Flanges
are stamped
steel. Flange covers have a triple plated
polished chrome finish.
q
61
-
F
–
Shower Rod Flange Set
Polished Chrome Finish
Concealed Screw Mounting
Two Assemblies per Set
Fits 1” Diameter Rods
1. Position rod in shower opening in desired location.
2. Mark rod ends on walls.
3. Position bracket
s so that they are centered over rod outlines and
mark mounting holes.
4. Drill starter holes.
5. Attach left bracket to wall using 1” screws (provided).
6. Slide left cover on left end of rod and mount on installed bracket.
7. Place right cover on right end of rod.
8. Insert right bracket into right end of rod.
9. Place end of rod in position and attach bracket to wall with 1”
screws (provided).
10. Snap covers into place over brackets.
Note: Wood blocking is preferable behind all wall surfaces.
If wood blocking is not availab
le, the following optional fasteners are
suggested: Tile/Masonry –
Plastic or Lead Anchors; Plaster/Drywall
– Toggle Bolts
Stock Number:
________________Shower Rod Flanges
By Creative Specialties
Materials:
Installation Instructions:
Stock Numbers:
Dimensions:
Shower Rod Flange Set
61
-
F
Shower Rods Technical Specification