Specification Sheet

Technical Specication
Mirror with Decorative Hardware BP1892
Stock Numbers: Dimensions:
BP1892CH – Mirror with Decorative
Hardware
Chrome Finish
BP1892BN – Mirror with Decorative
Hardware
Brushed Nickel Finish
BP1892BL – Mirror with Decorative
Hardware
Matte Black Finish
Materials:
Mirror with Decorative Hardware and
Posts are constructed of zinc alloy.
Stock Number: BP1892 Mirror with Decorative
Hardware
25300 AL MOEN DRIVE • NORTH OLMSTED, OH 44070
CONSUMER SUPPORT: [phone] • FAX: [phone]
INTERNATIONAL: (440 ) 962-2000 • FAX: [phone]
CUSTOMER SERVICE (USA): 800-882-0116 • FAX: [phone]
WWW.MOEN.COM
©
2018 Moen Incorporated.
25-7/16“
(635mm)
27-7/16“
(686mm)
36“
(914mm)
2“
(51mm)
2-15/16“
(51mm)
Installation Instructions:
Directions below are for installation into drywall. If installing product into a stud,
use the wood screws and washers provided only.
1. Remove the mounting bracket from the body by loosening the set screw.
2. Position the mounting template on the wall in the desired location. Using a
level, align the template and tape it to the wall.
3. Drill 1/2" pilot holes in marked location, remove template from wall.
4. Place mounting bracket over holes, align and trace both parts.
5. Attach mounting bracket to wallusing anchors in predrilled pilot holes.
6. Unscrew plastic nut from end post.
7. With the back of the mirror facing you, slide both end posts into position on
the mirror. Align the screw with the hole in the mirror.
8. Thread on plastic nut and hand tighten.
9. Place each post over the mounting bracket with setscrew down. Tighten both
setscrews.
Cleaning Instructions:
To preserve the ne nish of this product, clean only with a soft damp cloth. Dry
well. Do not use commercial or abrasive cleaners.