Specification Sheet

Technical Specication
Hand Towel Bar
BP1886
Stock Numbers:
Materials:
☐
BP1886CH - Hand Towel Bar
Chrome Finish
☐
BP1886BN - Hand Towel Bar
Brushed Nickel Finish
☐
BP1886BL - Hand Towel Bar
Matte Black Finish
Hand Towel Bar and Posts are
constructed of zinc. Rod is stainless
steel.
Dimensions:
Installation Instructions:
Cleaning Instructions:
To preserve the ne nish of this product, clean only with a soft
damp cloth. Dry well. Do not use commercial or abrasive cleaners.
1) Position the mounting template on the wall in the desired location.
2) Using a level, align the template and tape it to the wall.
3) Drill two 5/16" holes at each mounting plate location that corresponds to your product.
4) Remove the template from the wall.
5) Fold ends of the plastic toggle together and insert into each hole in the wall.
6) Lightly tap anchors until ush with the wall.
7) One at a time, insert plastic pin into each of the anchors and lightly tap to activate
anchor. Remove pin and repeat on all anchors.
8) Remove mounting plates from the posts by loosening each setscrew.
9) Place the mouting plate on the wall over the installed wall anchors with "UP"
facing you.
10) Insert screws through the mounting plate into the anchors and tighten.
11) Assemble the towel bar and posts.
12) While assembled, position each end post with setscrews facing down and place over
both mounting plates. Tighten the setscrews.
Stock Number: ____________BP1886 Hand Towel Bar
25300 AL MOEN DRIVE • NORTH OLMSTED, OH 44070
CONSUMER SUPPORT: [phone] • FAX: [phone]
INTERNATIONAL: (440 ) 962-2000 • FAX: [phone]
CUSTOMER SERVICE (USA): 800-882-0116 • FAX: [phone]
WWW.MOEN.COM
©
2019 Moen Incorporated.
5/8 “
(16mm)
2 “
(51mm)
9 “
(229mm)
2 “
(51mm)
3-1/8 “
(76mm)