Specification Sheet

Technical Specication
Hand Towel Bar
BP1803
Stock Numbers:
Materials:
☐
BP1803CH - Hand Towel Bar
Chrome Finish
☐
BP1803BN - Hand Towel Bar
Brushed Nickel Finish
☐
BP1803BL - Hand Towel Bar
Matte Black Finish
Hand Towel Bar is constructed of zinc.
Dimensions:
Installation Instructions:
Cleaning Instructions:
To preserve the ne nish of this product, clean only with a soft
damp cloth. Dry well. Do not use commercial or abrasive cleaners.
1) Remove mounting plate from the product post by loosening the setscrew.
2) Position the mounting plate on the wall at desired location with "UP" facing
you. Mark hole locations.
3) Drill two holes as marked using a 5/16" drill bit.
4) Fold ends of the plastic toggle anchor together and insert into each hole on
the wall.
5) Lightly tap anchors until ush with the wall.
6) One at a time, insert plastic pin into each anchor and lightly tap to activate
anchor. Remove pin and repeat on other anchor.
7) Place the mounting plate on the wall over the installed wall anchors with "UP"
facing you.
8) Tighten screws.
9) Place decorative product over the mounting plate with the setscrew facing
down and tighten setscrew.
Stock Number: ____________ BP1803 Hand Towel Bar
25300 AL MOEN DRIVE • NORTH OLMSTED, OH 44070
CONSUMER SUPPORT: [phone] • FAX: [phone]
INTERNATIONAL: (440 ) 962-2000 • FAX: [phone]
CUSTOMER SERVICE (USA): 800-882-0116 • FAX: [phone]
WWW.MOEN.COM
©
2019 Moen Incorporated.
2 “
(51mm)
2 “
(51mm)
2-1/4 “
(51mm)
2-5/16 “
(51mm)