Installation Guide

Description:
The ARC-4200 consists of easy
to install components for air
actuated on/o control for use
with food waste disposers rated up
to 120V/12 AMPS (1 HP) maximum.
Simply plug the ARC-4200 control
module into any standard electrical
outlet then plug the appliance into
the receptacle provided in the
control module. The appliance can
be activated and deactivated by
depressing an air button mounted
up to 10 feet away.
Warranty:
Moen products have been manufactured under the highest
standards of quality and workmanship. Moen warrants to
the original consumer purchaser all parts of this product to
be free from defects in material and workmanship during
normal use, for (1) year from date of purchase. A replacement
for any defective part will be supplied free of charge for
installation by you. Defects or damage caused by the use
of other than genuine Moen parts are not covered by this
warranty. This warranty shall be eective from the date of
purchase as shown on the purchaser’s receipt. Some states
do not allow limitations on how long an implied warranty lasts,
so the above limitation may not apply to you.
This warranty is valid for the original purchaser only and
excludes product damage due to installation error, product
abuse, or product misuse, whether performed by a contractor,
service company, or yourself. Moen will not be responsible for
labor charges, and/or damage incurred in installation, repair or
replacement, nor for incidental or consequential damages.
Some states, provinces and nations do not allow the
exclusion or limitation of incidental or consequential
damages so the above limitations or exclusions may not
apply to you. This warranty gives you specic legal rights
and you may also have other rights which may vary from
state to state, province to province, and nation to nation.
Moen Incorporated will advise you of the procedure to follow
in making warranty claims. Simply write to Moen explaining the
defect and include proof of purchase and your name, address
and telephone number. The address is: Moen Incorporated,
25300 AI Moen Drive, North Olmsted, OH 44070-8022, or call
our toll-free consumer Helpline: 1-800-289-6636.
In Canada, write to Moen, 2816 Bristol Circle,
Oakville, Ontario L6H5S7 or call: Toronto: 905-829-3400;
Rest of Canada: 1-800-465-6130, and ask for Product Service.
1
Ring
Button
Mounting
Shank
• Place the button inside
• Place the ring over the
button.
• Push the sides of the
ring until it locks with
the mounting shank.
• Reverse steps to change
button if new nish is
desired.
Attach Air Switch Button Mount Push Button
2
Mounting
Shank
Plastic Nut
• Place the Mounting
Shank directly through
a standard sink hole or
through the countertop.
Requires 1-3/8" diameter
hole.
• Tighten the plastic nut
completely to the
counter to ensure a
proper seal.
Attach Air Tube
3
Air Tube
• Attach air tube
between
the Mounting
Shank
and the control
module. Secure tightly.
Plug in Controller Base
4
• Plug controller base
cord into a grounded
120V household wall
receptacle.
Connect Controller Base and Disposal
5
• Plug disposal cord into
controller base.
• Press and release the
air switch button to
turn the disposal on.
Press and release the
button again to turn
the disposal o.
Test on/o function
prior to adding waste
to disposal.
CAUTION
Disposal may start when Controller Base
is plugged in.
Power Module Plug
Disposal Plug
1
Ring
Button
Mounting
Shank
• Place the button inside
• Place the ring over the
button.
• Push the sides of the
ring until it locks with
the mounting shank.
• Reverse steps to change
button if new nish is
desired.
Attach Air Switch Button Mount Push Button
2
Mounting
Shank
Plastic Nut
• Place the Mounting
Shank directly through
a standard sink hole or
through the countertop.
Requires 1-3/8" diameter
hole.
• Tighten the plastic nut
completely to the
counter to ensure a
proper seal.
Attach Air Tube
3
Air Tube
• Attach air tube
between
the Mounting
Shank
and the control
module. Secure tightly.
Plug in Controller Base
4
• Plug controller base
cord into a grounded
120V household wall
receptacle.
Connect Controller Base and Disposal
5
• Plug disposal cord into
controller base.
• Press and release the
air switch button to
turn the disposal on.
Press and release the
button again to turn
the disposal o.
Test on/o function
prior to adding waste
to disposal.
CAUTION
Disposal may start when Controller Base
is plugged in.
Power Module Plug
Disposal Plug
INS10534 - 3/18
©2018 Moen Incorporated
Moen Incorporated
25300 Al Moen Drive
North Olmsted, Ohio 44070-8022
U.S.A.
Moen de Mexico, S.A. de C.V.
Carretera Saltillo-Monterrey KM 14.7
Ramos Arizpe, Coahuila
Mexico 25900
Moen Incorporated
2816 Bristol Circle
Oakville, Ontario L6H 5S7
Canada