Specification

6-3/4"
(171mm)
12-1/8"
(308mm)
5-1/2"
(140mm)
10-1/8"
(257mm)
2-3/4"
(70mm)
2-3/4"
(70mm)
8-1/8"
(206mm)
1/2"
(13mm)
10-1/4" x 2-3/8"
(260mm x 60mm)
ESCUTCHEON
2-1/2" Max
Deck Thickness
2-9/16"
(65mm)
2-3/16"
(56mm)
29-1/2"
(750mm)
ARBOR™
Single Handle High Arc
Pulldown Kitchen Faucet
Models: 7294 series
NOTE: THIS FAUCET IS DESIGNED TO BE INSTALLED
THRU 1 OR 3 HOLES, 1-1/2” (38mm) MIN. DIA.
S p e c i fi c at i o n s
TO ORDER PARTS CALL: 1-800-BUY-MOEN
www.moen.com
FAUCET DESCRIPTION
• Reflex™ system offers smooth operation, easy movement and
secure docking
• Metal construction with various finishes identified by suffix
• Hydrolock® quick connect installation
• Pullout spray with braided hose
• Flexible supply lines with 3/8" compression fittings
• High arc spout provides height and reach to fill or clean large
pots while pull out wand provides the maneuverability for cleaning or rinsing
• 360˚ rotating spout provides ability to install handle on either side
OPERATION
• Lever style handle
• Temperature controlled by 100˚ arc of handle travel
• Operates with less than 5 lbs. of force
• Operates in stream or spray mode in the pullout or retracted position
• When filling a vessel outside the sink, the pause feature conveniently stops
the flow of water as the wand passes over the counter top
FLOW
• Flow is limited to 1.5 gpm (5.7 L/min) at 60 psi
CARTRIDGE
• 1255™ Duralast™ cartridge for Single-Handle Faucets
STANDARDS
• Third party certified to IAPMO Green, ASME A112.18.1/CSA B125.1 and all
applicable requirements referenced therein including NSF 61/9
• Meets CalGreen and Georgia SB370 requirements
• Complies with California Proposition 65 and with the Federal Safe Drinking
Water Act
• The backflow protection system in the device consists of two independently
operating check valves, a primary and a secondary which prevent backflow
•
ADA for lever handle
WARRANTY
• Lifetime limited warranty against leaks, drips and finish defects
to the original consumer purchaser
• 5 year warranty if used in commercial installations
CRITICAL DIMENSIONS
(DO NOT SCALE)
Rev. 2/12