Specifications

ManualsBrandsMoen ManualsPlumbing Product64625

CRITICAL DIMENSIONS

(DO NOT SCALE)

Spec i fi ca tions

FOR MORE INFORMATION CALL: 1-800-BUY-MOEN

www.moen.com

Rev. 3/11

There is more than 1 version of this model.

Page down to identify the version you have.

NOTE:THIS FAUCET IS DESIGNED TO BE

IN STALLED THRU 3-1" DIA. HOLES, 2" ON CENTER

CHATEAU®

Single-Handle Lavatory Faucet

with Metal Waste Assembly

Model: 4625 series

with 50/50 Waste Assembly

Bulk Pack (12 Per Carton):

64625 series

SPACER

PROVIDED –

DISCARD IF

MOUNTING

SURFACE IS

MORE THAN

3/4" THICK

1-3/4"

(45mm)

MAX.

DECK PLATE

Lift

Rod

TOP OF

MOUNTING

SURFACE

2-3/8"

(61mm)

ESC.

WIDTH

6-7/54" (156mm)

ESCUTCHEON WIDTH

(51mm)

4-3/8"

(111mm)

5-3/4" (146mm)

OFF POSITION

(51mm)

27-1/2"

(699mm)

3/8" (11mm)

COMPRESSION

FITTINGS

DESCRIPTION

• Metal construction with various finishes identified by suffix

• Flexible supplies with 3/8” compression fittings

• Includes metal or 50/50 pop-up type waste assembly where noted

OPERATION

• Acrylic knob style handle

• Tilt-on/Tilt-off

• Temperature controlled through 100˚ degree arc of handle travel

FLOW

• Flow is limited to 1.5 gpm max (5.7L/min) at 60 psi

CARTRIDGE

• 1255™ Duralast™ cartridge

• Nonmetallic/nonferrous and stainless steel material

STANDARDS

• Third party certified to WaterSense,® CSA B-125.1, ASME A112.18.1 and

all applicable requirements referenced therein including NSF61/9

• Contains no more than 0.25% weighted average lead content

• Complies with California Proposition 65 and with the Federal Safe

Drinking Water Act

WARRANTY

• Lifetime limited warranty against leaks, drips and finish defects to

the original consumer purchaser

• 5 year warranty if used in commercial installations

Summary of content (2 pages)

PAGE 1
Specifications There is more than 1 version of this model. Page down to identify the version you have. DESCRIPTION • • • Metal construction with various finishes identified by suffix Flexible supplies with 3/8” compression fittings Includes metal or 50/50 pop-up type waste assembly where noted OPERATION • • • Acrylic knob style handle Tilt-on/Tilt-off Temperature controlled through 100˚ degree arc of handle travel FLOW • Flow is limited to 1.5 gpm max (5.
PAGE 2
Specifications DESCRIPTION • • • Metal construction with various finishes identified by suffix 16" supplies Includes metal or 50/50 pop-up type waste assembly where noted OPERATION • • • Acrylic knob style handle Pull-on/Push-off Temperature controlled through 180˚ degree arc of handle travel FLOW • Flow is limited to 1.5 gpm max (5.7L/min) at 60 psi, for products made before October 2008 flow is limited to 2.2 gpm max (8.