Technical Specifications

Robe Hook
is die cast from highest
quality zinc alloy (zamac). Castings
are triple plated with a polished brass
or a polished chrome finish.
q
2030PB
–
Double Robe Hook
Polished Brass Finish
Concealed Screw Mounting
q 2030 – Double Robe Hook
Polished Chrome Finish
Concealed Screw Mounting
Cleaning Instructions:
25300 AL MOEN DRIVE • NORTH OLMSTED, OH 44070 [phone] •
FAX: [phone] • INTERNATIONAL: (440) 962- 2000 •
FAX: (440) 962
-
2726 CUSTOMER SERVICE (USA)
: 800
-
882
-
0116
1. Remove mounting bracket from back of fixture by loosening the set
screw.
2. Position unit on wall in desired location.
3. Lightly mark the outline of the base of the unit.
4. Center mounting bracket inside the outline.
5. Mark hole locations. Attach bracket to wall using 1 3/8” screws
(provided).
6. Mount base on bracket. Tighten set screw on the bottom.
Note: Wood blocking is preferable behind all wall surfaces.
If wood blocking is not available, the following optional fasteners are
suggested: Tile/Masonry – Plastic or Lead Anchors; Plaster/Drywall –
Toggle Bolts.
Stock Number:
______________________Robe Hook
By CSI Bath Furnishings
Materials:
Installation Instructi
ons:
Stock Numbers:
Dimensions:
Robe Hook
2030
Contemporary Technical Specification
To preserve the fine finish of this product, clean only with a soft
damp cloth. Dry well. Do not use commercial or abrasive cleaners.

Copyright CSI Bath Furnishing Division of Moen 02/22/01
Literature #BA0990