Installation Manual

5569/5570 QUEEN BED
STEP 5
C
H
H
5
6
6
6
B×5 C×1 F×1 E×6 H×1
Insert 5 pieces of Bolt (B) into the 5 holes on Center Rail (5) to connect it with
Support Leg (7) as shown.
Insert Bolt (C) into the holes on Center Rail (5)
and Stretcher
(6)
to connect it with
Support Leg (7)
as shown.
Secure the above 6 pieces of Bolts (B&C) with Nuts (E) &
from the bottom of Support Leg (7) at same time.
Use Allen Wrench (F) and Open Wrench (H) to tighten all Bolts (B&C) and Nuts (E) &
until secure.
Kx28
J
x14
I
I
K
12
12
Insert 2 pieces
of Side Plastic Cover (I) into each end of 2 pieces of Slat (12) as shown.
Insert the other end of the Slats (12) into 1 piece of Center Plastic Cover (J) as shown.
Insert the assembled Side Plastic Covers (I) into the corresponding holes on Side Rail (4), and the assembled Center
Plastic Cover (J) into the corresponding holes on Center Rail (5) as shown.
Repeat the same steps for the remaining 28 pieces Slat (12)..
STEP 6:
F
B
B
E
B
E
E
Hardware & Tool required
7
7
7
F
G×6
G
G
G
G
Flat Washer (G)
Flat Washer (G)