5569/5570 QUEEN BED QUEEN step-by-step Approximately and have B ×5 M6 C D M6 E M6 70 F G H 9 9 11 8 4 10 3 12 10 5 6 3 4 7 6 6 ×14 M6 Flat Washer 12 I Side Plastic Cover ×28 J Center Plastic Cover ×14 1 Post-1 2 Post-2 3 Post-3 4 Side Rail 5 Center Rail 6 Stretcher 7 Support Leg 8 Cross Bar-1 9 Cross Bar-2 10 Connect Bar 11 Headboard 12 Slat 8 ×36 20 ×1 ×1 ×2 ×2 ×1 ×3 ×3 ×2 ×2 ×2 ×1 ×28
569/5570 QUEEN BED Insert the connector on the Post-3 (3) into the Cross Bar-1 (8) as shown and then insert them into the corresponding holes on Cross Bar-1 (8) by using Bolts (A) and Allen Wrench (F) . Place Connect Bar (10) to the assembled Post-3 (3) by using Bolts (A) and Allen Wrench (F) as shown.
5569/5570 QUEEN BED Insert the connector on the Post-2 (2) & Post-3 (3) into the Cross Bar-2 (4) as shown and then insert them into the corresponding holes on Cross Bar-2 (9) by using Bolts (A) and Allen Wrench (F ) . Repeat the same steps for the remaining Post-1 (1) & Post-3 (3) & Cross Bar-2 (4). Place Side Rail (4) to the assembled Post-2 (2) and Post-3 (3) by using Bolts (A) and Allen Wrench (F ) as shown. Repeat the same steps for the remaining Post-1 (1) & Post-3 (3) & Cross Bar-2 (9).
5569/5570 QUEEN BED STEP 5 Insert 5 pieces of Bolt (B) into the 5 holes on Center Rail (5) to connect it with Support Leg (7) as shown. Insert Bolt (C) into the holes on Center Rail (5) and Stretcher (6) to connect it with Support Leg (7) as shown. Secure the above 6 pieces of Bolts (B&C) with Nuts (E) & Flat Washer (G) from the bottom of Support Leg (7) at same time. Use Allen Wrench (F) and Open Wrench (H) to tighten all Bolts (B&C) and Nuts (E) & Flat Washer (G) until secure.
