Installation Manual

Place Center Rail (7) and 4 pieces of Support Leg (6) under assembled Double Slat (4) and Single Slat (5) as shown.
Insert 4 pieces of Long Bolt (C) into the 4 holes right on Center Rail (7) to connect it with Support Legs (6) as shown.
Insert 4 pieces of Medium Bolt (B) into 4 other holes left on Center Rail(7) to connect it with Support Legs (6) as shown.
Secure the above 8 pieces of Bolts (B&C) with Nuts (E) from the bottom of Support Legs (6) at same time.
Use Allen Wrench (G) and Open Wrench (H) to tighten all Bolts (B&C) and Nuts (E) until secure.
5478
Take out all Double Slats (4), Single Slats(5) and Side Rails(3) and place them as shown.
Insert one end of Single Slats (5) into Rubber Insert (F), then insert them into the corresponding holes on one piece of
Side Rail (3) as shown.
Attach Double Slats (4) to the same Side Rail (3) by using Short Bolts (A). Do not fully tighten Short Bolts (A) with
Allen Wrench (G) yet.
Repeat above for the other Side Rail (3).
Use Allen Wrench (G) to tighten all Short Bolts (A) clockwise until secure.
i i