Installation Manual

Customer Service 908-368-1025︱

︱︱

︱www.modwayfurniture.com Page 2 of 6

Ax4 Bx4 Cx1

STEP 1:

Put the Headboard (1) upside down on a carpeted or padded area by two adults

Then insert the Low Posts (2) into the bottom of Headboard (1) and align pre-drilled Low Post (2) holes to the pre-

drilled Headboard (1) Holes according to your desired headboard height.

Attach each of Low Post (2) by using 2 piece of Flat Washer (B) and 2 pieces of Bolt (A) from the holes on the back

of Low Post (2) and Headboard (1). Tighten with Allen Wrench (C).

Hardware & Tool required

STEP 2:

Assembly is completed. The headboard is ready to use now!

NOTE: Hardware may loosen over time. Periodically check that all connections are tight.

Carefully turn up the assembled Headboard (1) by two adults.

Back

MODWAY HEADBOARD