Assembly Instruction

Custo

mer Service 908-368-1025︱www.modwayfurniture.com Page 1 of 2

Thank you for purcha

sing the MODWAY DINING TABLE！

Before you start, here is some helpful advice:

1.We suggest you spend a short time reading through this leaflet and then follow the simple step-

by-step

instructions.

2.Owing to the size and weight of the dining table, we recommend that it is assembled by two adults, on a

carpeted or padded area, in the room that it is intended for. Approximate assembly time: 30 minutes.

3.Please do not use any tools other than those provided or recommended in these instructions.

4.Please do not throw away any of the packaging or the instruction until you have checked all the components and

hardware and the furniture is fully assembled. Please ensure that the packaging is disposed of in a safe and

environmentally friendly way.

5.Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten the

components from time to time, so please save the tools that have been provided.

6.Please keep all fitting out of reach of children.

Hardwa

re:

Allen Wrench M5

Components:

Leg x

Top Frame

Flat Washer M8 x12

Bolt M8x40mm

x12

EEI-2874/ EEI-2875/ EEI-2876 DINNING TABLE

PAGE 1
EEI-2874/ EEI-2875/ EEI-2876 DINNING TABLE Thank you for purchasing the MODWAY DINING TABLE！ Before you start, here is some helpful advice: 1.We suggest you spend a short time reading through this leaflet and then follow the simple step-by-step instructions. 2.Owing to the size and weight of the dining table, we recommend that it is assembled by two adults, on a carpeted or padded area, in the room that it is intended for. Approximate assembly time: 30 minutes. 3.
PAGE 2
EEI-2874/ EEI-2875/ EEI-2876 DINNING TABLE STEP 1: Put Table Top (1) upside down on a carpeted or padded surface. Place 1 piece of Leg (2) to Table Top (1) as shown. Insert 6 pieces of Bolts (A) with 6 pieces of Flat Washers (B) into the pre-drilled holes on Table Top (1) through the pre-drilled holes on Legs (B). Use Allen Wrench (C) to tighten Bolts (A) clockwise until secure. Repeat the same steps for the remaining Leg (B).