Installation Manual

Customer Service 908-368-1025︱www.modwayfurniture.com Page 2 of 2
EEI–2671 CHAIR
STEP 1:
STEP 2:
Ax12 Bx12 Cx12 Dx1
Hardware & Tool required
Please put Chair Body (1) upside down on a carpeted or padded area.
Positon 1 piece of Back Leg (3) to the bottom of Chair Body (1).
Insert 3 pieces of Bolt (A) with 3 pieces of Spring Washer (B) and 3 pieces of Flat Washer (C) into the holes on
bottom of Chair Body (1) through the holes on Back Legs (3) as shown.
Repeat the same steps for the remaining Back Leg (3) and Front Legs (2).
Use Allen Wrench (D) to tighten Bolts (A) clockwise until secure.
D
Assembly is complete. Your chair is ready to be use now!
Carefully turn over the assembled chair.
A
B
C
C
B
A
A
A
B
C
B
C
1
3
3
2
2
Direction label towards front