Installation Manual

Customer Service 908-368-1025︱www.modwayfurniture.com Page 2 of 3
EEI –2234/2235 CHAIR
STEP 1:
STEP 2:
2
Ax4 Bx4 Cx4
Hardware & Tool required
A
C
B
Ax4 Cx4 Bx4
Hardware & Tool required
1
3
C
B
A
1
Please put Chair Back (1) upside down on a carpeted or padded area.
Then open the Velcro on bottom of the Seat Frame (2), The inside of the Seat Frame(2) will now be visible.
Attach Seat Frame (2) to Chair Back(1) by using 4 pieces of Bolt (A), 4 pieces of Spring Washer (B) and 4 pieces of Flat
Washer (C) as shown.
Do not fully tighten Bolt (A) at this step.
Insert 1 piece of Front Leg (3) into the bottom of Seat Frame (2) as shown.
Attach by 2 pieces of Bolt (A), 2 pieces of Spring Washer (B) and 2 piece of Flat Washer (C) as shown.
Repeat the same steps for Front Leg (3).
Do not fully tighten Bolts (A) for either leg.
2
3