Installation Manual

Customer Service 908-368-1025︱www.modwayfurniture.com Page 2 of 3

EEI –2230/2231 CHAIR

STEP 1:

Ax2 Cx2 Dx2

Fx1

Hardware & Tool required

Please put Chair Back (1) upside down on a carpeted or padded area.

Then open the Velcro on the bottom of Seat Frame (2), the inside of the Seat Frame(2) will now be visible.

Attach Seat Frame (2) to Chair Back(1) by using 2 pieces of Bolt (A), 2 pieces of Spring Washer (B) and 2 pieces of Flat

Washer (C) and 1 piece of Dowel (F) as shown.

Do not fully tighten Bolt (A) at this step.

Bx4 Cx4 Dx4

Hardware & Tool required

Insert 4 pieces of Bolt (B), 4 pieces of Spring Washer (B) and 4 pieces of Flat Washer (C) from the holes at the corner of

Seat Frame (2) into the Chair Back (1) as shown.

Do not fully tighten Bolt (B) at this step.

STEP 2: