Installation Manual

Customer Service 908-368-1025︱www.modwayfurniture.com Page 2 of 2
EEI –180
CHAIR
STEP 1:
STEP 2:
Ax4 Bx4 Cx4 Ex1 Dx4
Hardware & Tool required
2
C
Please put Chair Body (1) upside down on a carpeted or padded area.
Place Chair Base (2) to Chair Body (1) as shown.
Insert 4 pieces of Bolt (A) with 4 pieces of Spring Washer (B), 4 pieces of Flat Washer (C) through the holes on 4 pieces of
Plastic Washer (D) and Chair Base (2) into the holes on bottom of Chair Body (1) as shown.
Use Allen Wrench (E) to tighten all Bolts (A) clockwise until secure.
B
A
E
1
Carefully turn over the assembled chair.
Assembly is complete. Your chair is ready to be enjoyed now!
A
B
C
A
B
C
A
C
B
D
D
D
D
ATTENTION: 1.Make sure to position 4 pieces of
Plastic Washer (D)
between
Chair Base (2) and Chair Body (1)
you don't need to put
Plastic Washer (D)
between
2.If you buy EEI-1 0-CLR-TOP to match with the ,
Chair Base (2)
and
Chair Body (1)
Chair Base (2)
8