Installation Manual

Customer Service 908-368-1025︱www.modwayfurniture.com Page 2 of 3
EEI -1797 OTTOMAN
STEP 1:
STEP 2:
Please put the Ottoman Base (2) upside down on a carpeted or padded area by two adults to
make fully visible the corners.
Open the Zipper on the bottom of Ottoman (1) as shown, take out of the package of Legs (2) and Hardware Package.
Take out the 4pcs of Ottoman Legs (2) from the package, then close the Zipper on the bottom of Ottoman (1).
2
4pcs Leg
Zipper on the bottom
of ottoman body
+
Hardware Package
Position one of Ottoman Legs (B) at one of the four wooden corners.
Insert 2 pieces of Spring Washer (B), Flat Washer (C) into 2 pieces of Bolts (A) as shown.
Then insert assembled 2 pieces of Bolts (A) into the corner to connect the Leg (2).
Use Allen Wrench (D) to tighten the Bolts (A) clockwise until secure.
Repeat the same steps for the other three Legs (2).
Ax8 Bx8 Cx8 Dx1
Hardware & Tool required
2
3
3
3
3
A
A
A
D
A
B
C
2
3