Installation Manual

Customer Service 908-368-1025︱www.modwayfurniture.com Page 2 of 3
EEI –1053/1054 CHAIR
STEP 1:
STEP 2:
Please put Legs (2&3) upside down on a carpeted or padded area.
Attach Leg (3) to Leg (2) by using 1 pieces of Bolt (A) with1 piece of Spring Washer (C).
Use Allen Wrench (E) to tighten Bolt (A).
Do not fully tighten Bolts (A) at this step.
D
Ax1 Ex1 Cx1
Hardware & Tool required
Hardware & Tool required
2
3
3
2
3
Please put Chair Body (1) upside down on a carpeted or padded area.
Insert 4 pieces of Blot (B) through the holes on 8 pieces of Plastic washer (E) and Legs (2&3) into the holes on bottom of
Chair Body (1) as shown.
Use Allen Wrench (E) to tighten all Bolt (A&B) clockwise until secure.
Bx4 Dx8 Ex1
D
2
1
1
2
B
E
A
C
E
3
2
Note: The direction of arrow face towards front.